Plant rooms and water treatment
We design pool plant rooms and the hydraulic and water treatment systems inside them: pumps, filters, disinfection, heating and pipework. We also review existing or contractor-proposed systems independently, because Coreline does not sell equipment.
Aquatic engineering
Typical projects
- New commercial and community pool plant rooms
- Plant upgrades for existing facilities
- Independent review of a pool contractor's plant proposal
- Heating and energy efficiency upgrades
Problems this work solves
- Plant rooms that cannot be serviced
- Equipment that fits on the day of installation can be impossible to service later. Clearances for filter media changes, pump removal and chemical handling are often missed.
- Pipe losses and pump energy
- Small pipes and many fittings increase friction, and the pump pays for it every hour the pool runs. Pipe sizing is an energy decision.
- Chemical safety
- Disinfection chemicals need storage, bunding, ventilation and separation from incompatible chemicals. Plant room layout has to make safe handling easy.
What our engineering covers
Coreline's role is design, documentation, assessment and inspection. Construction, supply and installation sit with the builder and trades.
- Turnover, filtration and disinfection sizing
- Pump selection criteria and hydraulic calculations
- Plant room layout and access planning
- Heating system options and sizing
- Chemical storage and dosing layout
- Independent review of supplier designs
Design considerations
- Variable speed pumping
- Running pumps slower outside peak times can cut energy use substantially, provided turnover and treatment targets are still met.
- Filtration type
- Media, regenerative and cartridge filters differ in water use, footprint and maintenance. The right choice depends on the operator's staffing as well as the pool.
- Monitoring
- Automatic chemical control and monitoring reduce manual testing but need calibration and staff who understand them.
What you typically receive
The exact deliverables are set in the fee proposal for each project.
- Plant room layout drawings
- Hydraulic schematics and calculations
- Equipment performance specification
- Review report on supplier proposals
What to send us
- Pool layout and volume
- Expected bather load and opening hours
- Available plant room space and access
- Operator preferences and staffing
- Existing plant details for upgrades
Standards and regulations that usually apply
Which documents govern a design depends on the project. These are the ones most often relevant here; we confirm the applicable editions for each job.
- AS 3735
- Concrete structures that retain liquid, covering crack control, cover and watertightness.
- NCC (Building Code of Australia)
- Performance requirements for buildings. In Queensland NCC 2022 applies until 30 April 2027 and NCC 2025 from 1 May 2027.
Questions we are asked
Why does an independent engineer matter for pool plant?
A supplier's design is also a sales proposal. An independent review checks the plant is sized for the real bather load and operating cost, not for a product range.
How do you reduce a pool's running cost?
The biggest levers are pump energy, through pipe sizing and variable speed pumps, and heat loss, through covers and insulation. Filter backwash water and chemical use are the next largest.
Can you check why our pool water keeps going cloudy?
Yes. We review turnover, filtration, circulation and disinfection against the bather load. Cloudy water is often a sign that plant capacity or circulation does not match how the pool is used.
Need plant rooms and water treatment?
Tell us what you are building or assessing, where it is and what drawings or reports you already have. We will come back with questions, a scope and a fee.
- Phone
- 1300 924 666
- Registered engineer
- Mustafa Koc, RPEQ 35981 (Civil)
