Skip to content
Coreline Engineering

Residential structural design

We design the structure of houses, extensions and renovations: beams, posts, bracing, tie-down, suspended floors and steel or engineered timber members that fall outside the framing code. Builders and owners get drawings and certification for building approval.

Housing engineering

Typical projects

  • Architect-designed houses with large openings and cantilevers
  • Extensions and second-storey additions
  • Removal of loadbearing walls
  • Raising and building under Queenslanders
  • Duplexes and townhouses

Problems this work solves

Open plans and big openings
Wide openings and removed walls concentrate loads onto a few beams and posts, and those loads have to reach footings that can take them.
Bracing
Open plans and glazing reduce the wall area available for bracing. The house still has to resist wind, which may mean steel portals or engineered bracing.
Old meets new
An extension tied to an older house has to account for different footings and framing, or the junction cracks.

What our engineering covers

Coreline's role is design, documentation, assessment and inspection. Construction, supply and installation sit with the builder and trades.

  • Structural layout for beams, posts and load paths
  • Member design in steel, timber and engineered timber
  • Bracing and tie-down design
  • Suspended floor and deck design
  • Assessment of existing structure for alterations
  • Design certification for building approval

Design considerations

Steel against timber beams
Steel carries longer spans in a shallower depth, while engineered timber is lighter and easier for carpenters. Ceiling depth and access often decide.
Point loads to the ground
Every new post needs a footing sized for its load. This is often missed in renovations.
Framing code limits
Much of a house can be built to prescriptive framing tables. Engineering covers the parts that fall outside them.

What you typically receive

The exact deliverables are set in the fee proposal for each project.

  • Structural drawings with member sizes and connections
  • Bracing and tie-down plans where required
  • Design certificate for building approval
  • Frame inspection where engaged

What to send us

  • Architectural or draftsperson drawings
  • Site address for wind classification
  • Soil test for new footings
  • Photos and measurements of existing structure for renovations
  • Builder's preferred materials

Standards and regulations that usually apply

Which documents govern a design depends on the project. These are the ones most often relevant here; we confirm the applicable editions for each job.

AS 1720.1
Design of timber structures, including engineered and mass timber products.
AS 4100
Design of steel structures and the engineering aspects of fabrication, erection and modification.
AS/NZS 1170 series
Structural design actions: permanent, imposed, wind, earthquake and other loads used in every structural design.
NCC (Building Code of Australia)
Performance requirements for buildings. In Queensland NCC 2022 applies until 30 April 2027 and NCC 2025 from 1 May 2027.

Questions we are asked

Do I need a structural engineer for a house extension?

Usually yes for footings, any beam over an opening outside the framing tables, and the connection to the existing house. A builder or certifier can tell you which parts of your plans need engineering.

Can you engineer building underneath a raised Queenslander?

Yes. We design the new lower-level structure and footings and check the existing house above, including how its loads transfer once stumps are replaced or the house is raised.

What do builders need from the engineer for approval?

Structural drawings and a design certificate the building certifier can rely on. Clear drawings shorten approval and reduce questions on site.

Sources

Need residential structural design?

Tell us what you are building or assessing, where it is and what drawings or reports you already have. We will come back with questions, a scope and a fee.

Registered engineer
Mustafa Koc, RPEQ 35981 (Civil)
Add company, role and timing (optional)

We use these details only to respond to your enquiry. See our privacy policy. Please do not attach or paste plans here; we will ask for them by email once we have spoken.

Call 1300 924 666Discuss your project