Skip to content
Coreline Engineering

Retaining wall engineering

We design retaining walls in concrete sleepers with steel posts, reinforced blockwork, segmental blocks and concrete. Each design accounts for the height, soil, drainage and any load above the wall, such as a driveway, house or pool.

Housing engineering

Typical projects

  • Sleeper walls for residential cut and fill
  • Blockwork walls on boundaries
  • Walls supporting driveways or houses above
  • Walls next to pools
  • Terraced walls on sloping sites

Problems this work solves

Surcharge from above
A car, house or another wall above a retaining wall adds load that can double the design pressure. Many failures start with an unconsidered surcharge.
Water pressure
Walls without drainage carry water pressure as well as soil. Blocked or missing drainage is the most common cause of walls leaning.
Boundaries and neighbours
Walls on boundaries affect two properties. Footings and drainage must stay on the right side.

What our engineering covers

Coreline's role is design, documentation, assessment and inspection. Construction, supply and installation sit with the builder and trades.

  • Wall type selection for the site and budget
  • Design for soil, surcharge and water
  • Footing and post design
  • Drainage design behind and below the wall
  • Checks against nearby structures and services
  • Certification and inspections where required

Design considerations

Sleeper against block
Sleeper walls are fast and cheap but have a shorter life and height limits. Blockwork and segmental walls last longer and suit higher retained heights.
Terracing
Two lower walls can be cheaper than one tall wall, but the upper wall surcharges the lower one if they are too close.
Sewers and stormwater
Walls near sewers and stormwater pipes may fall under QDC MP 1.4.

What you typically receive

The exact deliverables are set in the fee proposal for each project.

  • Retaining wall drawings and details
  • Drainage details
  • Design certificate for building approval where required
  • Inspection certificate where engaged

What to send us

  • Site survey with levels
  • Proposed wall location and height
  • What sits above the wall: driveway, house, pool, slope
  • Soil test if available
  • Location of sewers and stormwater

Standards and regulations that usually apply

Which documents govern a design depends on the project. These are the ones most often relevant here; we confirm the applicable editions for each job.

AS 4678
Design of earth-retaining structures, including segmental block and reinforced soil walls.
AS 3700
Design and construction of masonry structures.
QDC MP 1.4
Building work over or near sewers, water mains and stormwater drains, including clearances and service provider approval.

Questions we are asked

Does my retaining wall need an engineer in Queensland?

Generally yes, if it is over 1 metre high or carries a surcharge such as a driveway, building or another wall nearby. Check with your certifier or council, because the trigger depends on height, location and loads above.

How long does a sleeper wall last?

Concrete sleepers with galvanised steel posts last considerably longer than timber sleeper walls, but the drainage behind them and the corrosion protection of the posts largely decide their life.

Why is my retaining wall leaning?

Common causes are water pressure from blocked or missing drainage, a surcharge the wall was not designed for, or footings too shallow. An inspection identifies which before repair.

Sources

Need retaining wall engineering?

Tell us what you are building or assessing, where it is and what drawings or reports you already have. We will come back with questions, a scope and a fee.

Registered engineer
Mustafa Koc, RPEQ 35981 (Civil)
Add company, role and timing (optional)

We use these details only to respond to your enquiry. See our privacy policy. Please do not attach or paste plans here; we will ask for them by email once we have spoken.

Call 1300 924 666Discuss your project