Housing engineering
Coreline engineers single houses, extensions, duplexes, unit sites and small subdivisions: footings and slabs, the structure of roofs, walls and floors, retaining walls, stormwater and drainage plans, and stage inspections. We design to the site classification in your soil report and tell you early if the site needs more testing.
5 services
On a house, the footing system is chosen by the soil. A highly reactive clay site in Logan, a filled lot in a new estate and a sloping block on rock each call for a different slab and footing, and the cost difference between them can be larger than any saving made elsewhere in the structure. We start from the soil report and the site survey, then design the slab, the retaining and the drainage together, because surface water that ponds against a slab edge undoes a good footing design.
For renovations and architect-designed houses we design the framing, beams, posts, bracing and connections that sit outside the scope of the timber framing code, and we check what an extension or a removed wall does to the existing structure. Builders get drawings and certification the certifier can process without a round of questions.
We also inspect footings, reinforcement and framing during construction, and inspect existing houses when cracking, movement or a defect dispute needs an engineer's opinion.
Housing engineering services
- Residential structural designStructural design of beams, bracing, floors and roofs for new houses, extensions, renovations and architect-designed homes in south-east Queensland.
- Footings and slabsResidential footing and slab design to AS 2870 from your soil report, for reactive clay, filled lots and sloping sites across south-east Queensland.
- Retaining wall engineeringRetaining wall engineering in sleeper, blockwork, segmental block and concrete, designed for height, surcharge and drainage in south-east Queensland.
- Stormwater and drainage designStormwater and drainage plans, lawful point of discharge design and cut-and-fill plans for houses, duplexes and small developments in Queensland.
- Residential engineering inspectionsFooting, slab and frame inspections during construction, plus inspections of cracking and movement in existing houses across south-east Queensland.
Also within this discipline
Work we take on as part of a wider engagement. Ask us if your project needs it.
- Engineering for small subdivisions, re-subdivided lots, unit sites and retirement villages
- Coordination with surveyors, geotechnical firms and building certifiers so approval documents line up
Questions we are asked
What is a site classification and why does my footing design depend on it?
A site classification describes how much the ground is expected to move as its moisture changes, from stable sand and rock to highly reactive clay, along with problem sites such as uncontrolled fill. AS 2870 uses the classification to set the type and stiffness of the slab and footings, so the classification in your soil report drives the design and much of the slab cost.
Do you do the soil test?
We do not carry out the soil testing ourselves. We tell you what testing the site needs, review the report once it arrives, and design the footings and slab to its classification. If the report leaves questions, for example about fill depth or rock, we say so before the design is issued.
Do I need an engineer to remove a wall in my house?
If the wall is load bearing, or carries bracing for the house, yes. The engineer works out what the wall supports, sizes the beam and posts that replace it, and checks that the loads reach a footing that can take them. A non-structural partition can usually come out without engineering, but that has to be confirmed first.
When does a retaining wall need engineering in Queensland?
Retaining walls over 1 metre high, and walls of any height that carry a surcharge such as a driveway, building or another wall within the zone behind them, generally need building approval and an engineered design. Check with your certifier or council, because the trigger depends on the wall's height, location and what sits above it.
Have a project that needs engineering input?
Tell us what you are building or assessing, where it is and what drawings or reports you already have. We will come back with questions, a scope and a fee.
- Phone
- 1300 924 666
- Registered engineer
- Mustafa Koc, RPEQ 35981 (Civil)
